To speed up the process, use a carpet cleaner vacuum or something similar to suck out as much water as possible. Rinse the shampooed carpet again with water before leaving it to dry. Use a brush if necessary to remove any stubborn dirt still clinging to the fibers. To remove the bleach odor from the carpet, as well as any remaining dirt, flush the carpet with water thoroughly, and apply carpet shampoo afterward. Allow the bleach to sit on the carpet for about 30 minutes to one hour. Since the bleach will leave the carpet lighter in color, spray the carpet evenly with the solution until the entire thing is treated. However, in most cases, it is best to spray the whole surface area of the carpet with the solution to ensure uniformity in hue. If the carpet is all white, a part of it can be sprayed with the solution without leaving any unevenly colored surface.
The fumes that the combination of bleach and ammonia produce can be fatal. Important: Never let bleach come in contact with other chemicals, specifically ammonia, a chemical that is also used for cleaning. If possible, take the carpet to a place with fresh air. Before proceeding with the application of the solution onto the carpet, allow the room or the working area to be well-ventilated. Instead, mix a good bleach solution in a container by adding a cup of bleach to a gallon of water, and then pour the mixture into a spray container. Using bleach directly on the carpet will definitely stain it even further. Just a drop of bleach on one’s hands may cause undesirable effects so exercise extreme caution when handling it. You will often see bleach cleanable on the back of the sample. Step 2 – Prepare the Bleach Solutionīefore preparing the bleach solution, make sure to cover your hands with rubber gloves and wear a mask to protect the respiratory system from the strong odor emitted by bleach chemicals. Theoretically a polypropylene carpet can be cleaned with bleach. Before proceeding with the application of bleach, use a vacuum cleaner to suck up all the dirt and debris still clinging to the carpet. If there are any caked substances sticking to the carpet, use a knife to loosen them up to clean afterward. If your carpet is moldy, use a mold cleaning product first to get rid of the spores sticking to the carpet fibers. Understand that bleach does not easily remove molds from carpet.
Using prohibited solutions will void your warranty. Some warranties prohibit the use of certain chemicals and solutions on stain resistant carpets. Important : before you attempt this method check what your warranty says.